Water Heater Maintenance Tips for Homeowners
As a homeowner, it is very important to have a good water supply to your house. There are many uses for water. One thing about the water that is very important is the temperature of the water. If the weather is not hot, then cold water is ideal. Warm water is important when it is cold. Because of this, you must have a water heater. Considering that most people with water heaters use it all the time, it is what that consumes a lot of energy in the house. The only way to be able to have the water heater for long is to give it proper maintenance. The number of maintenance tips is high. In this article we take a look at some of the best water heater maintenance heaters that you can use as a homeowner.
To begin with, you should be flushing the tank once a year. If you have a water tank you should always ensure that it is flushed. There will be no sediment build-up in the water heater if it is flushed. If there is a high number of sediments then the energy that the water heater will need to heat the water will be very high. At the end, you will get a very high number of sediments.
Secondly the water heater should have some insulation on it. This is a very good way to make the water heater last for a long. You should use a good insulating material such as insulating foam. Insulating the water heater will prevent heat from leaving the water heater. The end result is that you will have a more efficient water heater. If it is possible you should also insulate the pipes that connect to the water heater.
The third maintenance tip for you to follow is that the air filters should be cleaned. Ideally the water should not contain any kind of debris. The only time that debris can get in the tank is if the air filter is not working okay. And the debris will damage the water heater from inside. Air filters can be washed by hand.
One more thing that you should have a look at is the anode rods in the tank. The anode rods are what rust in place of the tank The tanks usually will not rust at all because of the anode rods since they will take their place and rust. If they have rusted too much you must remove them. Otherwise, the rush will start attacking the water heater. One last thing to check is the TPR valve.